Onlyreon
Rex Krueger from patreon
Rex Krueger patreon

The Real Lathe Pt. 2: Make your own pulleys

🕑 Added 2018-10-19 21:10:41 +0000 UTC
The Real Lathe Pt. 2: Make your own pulleys

Comments

Aaron Sprague

It's on the list. Still need a motor for my lathe though.

Rex Krueger

You should! I've only been turning for a bit over 2 years and I've sold work, made MANY gifts, and I have a turning video with over 300K views on YouTube. It wasn't hard to pick up and I got decent at it pretty fast. Very satisfying.

Aaron Sprague

You make me really want to turn some wood.

James Boatright

Alana 2 hubs. Missed that. Good.

Rex Krueger

Good points! 1.) The shaft is mild steel, so I can add indexing holes anytime, and I will if I need them. I've thought a bat about doing this already. 2.) There are 2 hubs and the screws are offset from each other 180 degrees. The spindle runs true without vibration (so far) so i think I'll be okay. Thanks for the useful feedback!

James Boatright

So, I'll just make two comments... My experience with set screws without flats or holes for them to index on is poor. Good luck. 2] aren't you introducing an out of balance condition with only 1 set screw on one side? Oh well, if it rattles, I suppose you can drill another hole.


More Creators