Onlyreon
Rex Krueger from patreon
Rex Krueger patreon

The puzzle of the low-angle plane

🕑 Added 2018-10-31 15:09:20 +0000 UTC

Comments

Rex Krueger

And it's cheap!

Rex Krueger

Lower-case s, as in Blacksmiths. For about 4 months now.

Jim Williams

1095 steel is very good for heat treating. The Marine K-Bar is made of this steel as is the USAF Survival Knife.

James Boatright

See? You study with Smith's.

Rex Krueger

James, you seem to already know a lot about steel, so I'm not sure you need my input. Still, I think that O1 is an ideal choice (although "plain" steel generally refers to low-carbon steel and O1 is a high-speed steel; it's just semantics). 3/16 is my preferred thickness; thicker than a standard Stanley iron, but thin enough to actually sharpen. I've used 1095, which is cheaper, with excellent results. Also, I'd say that 20 inches will get you 4 blades for low-angle or krenov-style blades. I would avoid leaf-spring unless its free. It often has micro-cracks that don't reveal themselves until you've done all the work. The smiths I study with use it sometimes, and they have a lot of horror stories. Good luck!

James Boatright

So, I've been trawling on line tool steel dealers. What thickness do you think is ideal for these low angle planes? I've been seeing 2 inch by 20 inch by 3/16 for around $25 in O1. I'm thinking that a "plain" steel like that with only a touch of Mg designed for oil quenching that I can temper in the toaster oven makes sense, and you ought to be able to get 3 blades out of that. The alternative is to try the leaf spring trick. If you cut it, he at to austintite temps, flatten with a hammer, re heat and quench, the various sites I have been reading suggest the outcome is good, and truck springs can be had for a couple of bucks at salvage yards...


More Creators