Onlyreon
Rex Krueger from patreon
Rex Krueger patreon

Process Notes: Building a Lathe Headstock

🕑 Added 2018-10-01 12:00:03 +0000 UTC

Comments

Rex Krueger

No trouble. I really always have time for my Patrons.

Jim Williams

That is what I was missing.

James Boatright

George, hes wonderful about replies. And yes, the old metal lathe gi low thing is a great idea

George B

wow, thanks for taking the time to reply, I really appreciate it!

Rex Krueger

I like my tool-rest to be at or below elbow height. Figure that out and work backwards and you should be happy.

Rex Krueger

Chain drive is dangerous in a lathe because it can't slip. Get a bad catch or have some other mishap and something is going to break...badly. Belts slip and provide SOME safety.

Rex Krueger

Oh ye of little faith! I have plans to counter twisting. But we'll see.

Rex Krueger

So, the cross-braces aren't ideal for the belt, but I need them and there aren't many other places they can go. I plan on making a counter-shaft to control speed. I have a fairly complicated one in mind that will give 8 speeds in a high and low range. I think the motor will be down near the bed of the lathe and the countershaft will be mounted up pretty high. This was a common arrangement in metal lathes for a long time and that angle should minimize any belt problems. Good eye!

Aaron Sprague

Looking good, nice right up. I have yet to set up my lathe. What is a good bench height?

Jim Williams

Will this be a belt drive or chain drive? Chain drive would reduce the chance of deflection, but may not work for other reasons that I am not seeing at this moment.

James Boatright

Depend on where the motor goes, but he's got a 3 step, and thus 3 speed pulley in the photo. I'm just not convinced that those pipes are stable enough. I fully expect this to twist.

George B

Looking good! a shorter headstock is definitely more stable. those wooden cross-braces between the 2 parts of the head - won't they interfere with the motor belt? also, I'm curious about speed control, if and how you plan to implement it. I guess that depends on the type of motor, so I'll just wait and see :) good luck!


More Creators