Rex Krueger patreon

Exclusive Video: Shaker Table Pt 11.

🕑 Added 2024-09-11 11:00:10 +0000 UTC

Comments

Kenneth Carlile

My thought is that I'd rather bruise the wood than my finger... ;) Perhaps a dowel or something to lever against?

Eric Kmentt

I'm new here and missed the previous videos in the series. Are they available?

Skipper

I am a amateur like many others here but I feel that one early experience qualifies me to add a tip !! Always check that you are cutting a mortise in the correct place! The best mortise I have cut so far was between the wrong marking gauge lines so that the wood was in the wrong orientation! Good luck all 😜

Jennessa Lynam

That's the same way I do my mortises but they don't come out looking as good probably cause I use a bench chisel and not a mortise chisel. I've been wanting to get a couple but haven't had the money to get any. Hopefully I can change that soon. Thanks, Rex.

Helge

I am not even following along with the build, but I enjoy this series so much! The forum, the free plans, and bonus content like this would all be worth the patronage on their own imho. Any chance you´ll do a build-along again next year? any chance we´ll get an AMA after this one is finished (would completely understand if that is not your thing, just asking)

Chris St. Cyr

For years, I thought there was only one right way to cut mortises, the method of working away from the middle. I’ve learned the method doesn’t matter as long as you end up with a rectangular hole that is the right size!