ggwargame patreon

News. About July release (Jungle Warriors)

🕑 Added 2022-06-30 23:01:50 +0000 UTC

Comments

The stand is separately in the folder. Well, if you send me a PM, I'll send it

Harold

What I downloaded bases was on the stl file only the sniper did not have base but all others had figure weapon and base all on the same stl

Bases are already separated from models everywhere.

Harold

Will you be sending out another set of stl files where the figure, weapon and the base are separated I use other bases and dont want to waste resin on bases I will not use

David Sives-Rutherford

loving these

Tharehl101

Re-downloaded and re-printed new files and file 2 sword failed but could be my setting I use really fast settings. This is one of the reasons I always use my own supports. Model 1 looks good now and printed fine.

How to get tell what happened?

Tharehl101

Sorry man I have 2 printers a mars 2 pro and a Saturn. I always have problems with pre supported models. This is why I always do my own supports. But, there wasn't any that wasn't supported to test with. I tried the 2nd model on both printers and failed on both. I'll re-download the new files and try them again later tonight. Not at home right now sorry man.

Models updated. Everything is fixed

Until there is a new release, the old release will remain in effect.

Aevox23

Hi, new Patron here. Is there any way to receive/purchase rewards from previous months? If so how does that work? Thanks.

Are these test models. I check everything before release. What printer did you print to?

Tharehl101

Model one doesn't have a belt on its front side. Model 2 failed to print 2 times. Printed the others fine. All seem a bit undersized to me, used 28mm scale ragdoll to test next to.