Nic Wilson
patreon
Ender2 / Ender2 Pro Source Code
🕑 Added 2023-04-01 03:12:49 +0000 UTCUPDATED:
Fixed various issues.
New source code to suit Ender 2. See QuickSetPrinter at top of configuration config for basic options.
Comments
Ok will do this week. Ty
Nic Wilson
try new version I posted
Nic Wilson
It may not be fully enabled I will need to look at it
Maybe it's me but baby step z under tune does not seem to work the way I expected. I was using tiny machines firmware prior and that number under your firmware is zero to start when I had previously put in -1.10 with z probe. When you live tune it it again does not display what you put in if you go back to the setting again. Shows zero. If that makes any sense.
