Onlyreon
taofledermaus from patreon
taofledermaus patreon

How to make a .69 Cal. Minie Ball work in a .73 cal Shotgun

🕑 Added 2019-03-18 22:45:06 +0000 UTC
How to make a .69 Cal. Minie Ball work in a .73 cal Shotgun

Comments

James Jones

I don't know how you put up with all the trolls that bad wrapping all the time. I would just tell them to fuuk off. Just kidding, I know you can't do that on YouTube.

Stephen Wilcockson

Very interesting video, thanks for clarifying the situation. I knew you were doing it right all along.

Dr. Strangelove

Thanks for the tutorial, Jeff. Too bad that there isn't an alternative to YT. Back in the old days when a tranny went between the motor and the driveshaft we didn't have these problems.

Matthew (mel_the_nut) Elvers

It went bang and down range, can't see how you were doing anything wrong :)

Liberty4Ever

Filling the cavity *decreased* the bearing surface. You said it wrong! :-)

George Steele

The obvious solution is to swage the barrel down to an internal diameter of .69 - c'mon - how hard is that to figure out? (;-) A very well-thought out solution to the particular challenges of the hollow-based Minie ball. I particularly liked the choice of a more robust gas seal, as well as the notion of the rim bearing surface causing collapse of the shot cup base. I wonder how it would work to fill the base with shot? Always interesting, always thought-provoking thoroughly analyzed procedures. Great.

Kiono Hiemalis

Thanks for this very imformative video! That is one of the reasons why I love your channel so much! Another is of course shooting exotic and weird stuff, along with the destruction it brings.


More Creators